Hi there! This week I found a different way to print with supplies I had on hand. Thought I’d pass it along to you.
I had been mounting my stamps using Gorilla Glue and wood blocks but sometimes I want to tweak the stamp and once something is Gorilla glued, there’s no turning back. This technique is simple and allows me to use the block over and over. I got the blocks here 50% off so they were both less than $10.
I found two different ways to make these stamps and here’s what I used…
Add a couple of strips of the double sided tape to the block. Sketch your design onto a piece of thin foam. I used the template to draw lots of circles. Then stick the cutouts to your block.
The small stamp is the easiest because I cut out the stem and used the hole punch to punch out lots of little dots. Then, using the tape as described above, I stuck my cutouts to the block and it was ready to go.
You can barely see the tape attached to the block.
I hope you’ve been inspired to play!
52 Weeks of Print
Click here to see weeks 1-13