Watercolor Painting 101 is a place to learn about the art of watercolor in a relaxed, non-threatening way. If you’re new here, please take a look at the watercolor 101 page to see earlier lessons. For today, we’ll learn how to make a simple flat wash and then we’re going to get creative.
For this exercise you can use either a larger round brush (size 8 or 10) or a 1″ flat brush. The flat brush will be easier, but you can use either. You’ll also need a pencil, your watercolor paper, paints, a paper towel and a jar of clear water. Before getting started, add a few drops of water to your paints and grab a beverage while they loosen up.
Let’s get going…
First, draw a rectangle on your watercolor paper. Don’t worry about being precise – I freehanded mine and remember, this is supposed to be fun. So, have at it without any stressing.
With your brush and clear water, lightly dampen inside the rectangle. Now, load your brush (also called charging your brush) with a deep color wash. I used ultramarine blue.
Tilt the watercolor pad a little as you’re working and pull your brush across the top (left handed – pull right to left. right handed – pull left to right) Recharge your brush and begin line two, overlapping the previous line a little. Repeat until you reach the bottom. Your paint may drip. If this bothers you, dab the bottom edge of the rectangle with your paper towel to pull up the paint.
As the paint dries it should blend pretty well. You, my friend, have just completed your first flat wash. Take a bow.
Ready to keep going? Okay. While your paint is still a little wet…
Step 1: Add a few drops of water to your flat wash as shown. Notice how the water interacts with the colored wash, pushing back and intensifying the colored edges? This is called a backwash and depending on the effect you’re looking for, a backwash can be a wonderful thing or a bad thing. For us? It’s a wonderful thing.
Takeaway Tip: If you’re aiming for a smooth and even layer, don’t add any more paint to a damp wash or you could walk away with a serious case of backwash. A backwash happens because you’re combining varying degrees of dryness.
Dab a little of the clear water area with your paper towel to remove some of the main wash, creating an interesting effect. (this paper towel trick is a great way to make clouds when doing a sky wash!)
Step 2: Begin adding color by simply dripping and dabbling in bits of paint. Yep, that’s it. Drip away in a haphazard fashion. Continue adding color to create greens, purples, and oranges while remembering…
Takeaway Tip: Make sure that you don’t have too many areas with the three prime colors completely overlapping. If you do, and according to lesson one, you will end up with mud. So, unless you’re looking for mud, stay away from combining all three colors.
Steps 3 and 4: Allow some areas to dry and apply more layers, playing with backwashes and color effects. Use your paper towel and dab it onto different areas.
Part two will involve your gorgeously colorful abstract painting and a fine black marker. I’m showing you three here, a Micron pen, fine Sharpie pen, and a Faber-Castell artist pen. Any fine black marker will do.
Part two should appear early next week. Questions? Fire away and I’ll give it my best shot.
Finished your flat wash? Link up here to share your work.